Pf Motor - Epson Stylus Office T1110 Service Manual

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100

4.5.2 PF Motor

1. Remove the Printer Mechanism.
Mechanism (p.86).)
2. Disconnect the PF Motor connector cable from connector CN116 (black) on the
Main Board, and remove it from the Clamp on the Main Frame.
3. Remove the two C.C. M3 x 4 screws that secure the PF Motor.
4. Remove the PF Drive Belt from the PF Motor Pinion Gear, and remove the PF
Motor from the Printer Mechanism.
PF Motor connector cable
CN116
Figure 4-152. Removing the PF Motor
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
(Refer to 4.4.4 Lower Housing / Printer
PF Drive Belt
Clamp
1
2
Pinion Gear
PF Motor
11) C.C. M3x4
(4±0.5 kgf.cm)
Make the slit on the PF Motor face the direction shown in the
A D J U S T M E N T
R E Q U I R E D
figure below.
Tighten the screws in the order shown in
After replacing or removing the PF Motor, always make the required
A D J U S T M E N T
R E Q U I R E D
adjustments referring to the following.
• "Chapter 5
打印机驱动下载 http://www.printerwhy.com/
Removing the Motors
Slit
Figure 4-153. Reinstalling the PF Motor
Figure 4-152
Adjustment (p.128)"
Revision A
122
Confidential