Epson Stylus Office T1110 Service Manual page 80

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
5. Remove the coil section of Torsion Spring 24.7 from the tab on the Left CR Shaft
Mounting Plate with tweezers.
Left CR Shaft
Mounting Plate
Torsion Spring 24.7
Figure 4-32. Removing the Torsion Spring 24.7 (1)
6. Remove Torsion Spring 24.7 from the CR Scale by the following procedure:
6-1. Stand the coil section.
6-2. Lower the coil section downwards to remove Foot 1 from the notch on the
Left CR Shaft Mounting Plate.
6-3. Turn the coil section counterclockwise.
6-4. Remove Torsion Spring 24.7 from the hole on the CR Scale.
Step 6-3
Figure 4-33. Removing the Torsion Spring 24.7 (2)
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
Tab
Step 6-1
Foot 1
Notch
Step 6-2
Disassembling the Printer Mechanism
7. Turn the CR Scale 90º, and remove it from the tab on the Left CR Shaft Mounting
Plate.
Figure 4-34. Removing the CR Scale
打印机驱动下载 http://www.printerwhy.com/
Revision A
Tab
80
Confidential