Option 47 - Remote Access - Honeywell Galaxy 2 Series Installation Manual

Galaxy 2 Series Installation Manual

Option 47 - Remote Access

1 = Service
This option allows a user to initiate a call to the remote service centre or authorise a call in from the remote
servicing centre. On entering the menu, the user can select which communication device is used.
1 = Telecoms
5 = GSM (2–44+ only)
Upon selecting the device, the user can select which communication device is used.
0 = Direct Access
This enables a five minute window where the panel will accept an incoming call for the remote servicing
software.
1 = Start Call Out
This immediately initiates an outgoing call to the number pre-programmed in menu 56.1.12 or 56.5.12.
Option 48 - Level 3 Access
This option is a command which allows a normal user to authorize access for an engineer/master. This is
always required for an engineer code. It is also required to authorize access for a Master code, if the system is
set up this way by parameter 16. Authorization will be granted for five minutes. The engineer code must be
entered within this time. Two sub-options are available:
0 = Disabled
This is always the option shown first.
1 = Enabled
Authorization is granted for five minutes.
Upon leaving engineering mode, the engineer's code can regain access for up to 30 minutes, before manual
authorisation is required again via menu 48.
If the engineer PIN code has a # assigned, then the engineer can gain access by entering his PIN code twice.
The first entry of the PIN code will generate a tamper alarm on the keypad.
47 - Remote Access
57