6160 Keypad/Keyprox/Rfh (2-44+ Only); Installation And Wiring - Honeywell Galaxy 2 Series Installation Manual

Galaxy 2 Series Installation Manual
6160 Keypad/Keyprox/RFH (2–44+ Only)
The 6160 keypad is an addressible, alphanumeric remote keypad for setting/unsetting the Galaxy 2–44+
control panel. It is also available as a combined keypad/keyprox unit (keypad with built-in proximity card
reader). The keyprox version allows the system to be set and unset with keytags and cards. (see Section 6:
General Operation).

Installation and Wiring

The keypad can be surface mounted directly to a wall or electrical box. The keypad has a built in tamper
switch to detect separation of the back case from its mounting surface. An additional mounting screw must be
inserted in the tamper tab in the back case.
1. Press down the two base clips located at the rear edge of the keypad while gently pulling the two halves
of the case apart.
2. Route the wiring from the control panel through the cable entry hole in the back case. Use the knockout
holes if alternative routes are necessary.
3. Securely mount the back case to a wall or electrical box via the mounting holes. Ensure the tamper tab is
securely screwed down.
4. The keypad PCB must be wired to the control panel PCB as shown in Table 6. ECP Peripheral Wir-
ing.
5. Reattach the keypad to the back case.
1
A
B 4
ent 7
esc
*
Figure 26. 6160 Keyprox
Figure 27. Wiring Entry (Back case)
35
6160 Keypad
2 3
5 6
8 9
0
#