Honeywell Galaxy 2 Series Installation Manual page 94

56 - Comms (cont'd)
2 = Access Mode
This option determines what authorisation is required for remote service connection. There are two options:
1 = Direct Access
This permits access anytime. The remote centre can dial directly to the panel and gain access. If a call-back
number is programmed in option 3, then connection must be made by the call back procedure.
2 = Manager Authorise
This requires the user to authorise the remote servicing call via menu 47. The panel will not answer an incom-
ing call without authorisation.
3 = Callback No.
Remote servicing software requests the Galaxy 2 Series to call back the programmed telephone number.
4 = Downloader ID
This option specifies an eight-digit ID number for panels communicating via the remote servicing software.
This option defaults to 99999999. This is a security number and cannot be viewed at the keypad.
17 = SMS Paging
As a secondary alarm notification to keyholders, facility for sending SMS messages to a maximum of 3 mobile
phones or special equipped land lines, is incorporated. This comms format will only transmit once any Primary
signalling programmed, has successfully completed or has finished all redial attempts.
The panel dials the message centre number and leaves a message for each of the mobile phone numbers
programmed, according to the selected event type groups.
If a call is being made to an SMS centre number and a new event occurs which needs to be sent to the main
alarm reporting station, the call to the SMS centre number will be completed normally before the primary
number is dialled.
The following table lists the event types for this option:
For each of the above events, the full text event log entry for each event, including the additional info display, is
sent as an SMS message. Note that for alarm activations, only the first two alarm activations in each set
period will be sent. This will be reset at rearm.
If a kiss-off is not received, the system redials for two minutes. These redials are within 5-10 seconds of the
previous call. There is no comms fail fault condition generated if the calls are not successful, but an SMS fail
event is logged.
Galaxy 2 Series Installation Manual
T y p e E v e n s t
1 l A r a m e e v n s t
2 l A r a m a n d S t e
3 l A r a m a n d F a t l u
4 A l l E e v n s t
Table 26. Event Types
86