Full Setting; Part Setting - Honeywell Galaxy 2 Series Installation Manual

Galaxy 2 Series Installation Manual
To navigate around the menu and enter data, the keys are used as follows:
0-9: numeric data entry.
ent: accepts current display or enters selected option.
esc: escapes out of selected option.
A> B<: scroll forward and backward in menu or selected option. Many of the menu options shown
above will have one or more sub-menus below them. A user will be timed out of the menu structure if no keys
are pressed for two minutes. The engineer is not subject to timing out.

Full Setting

Before setting the system:
• Ensure all doors and windows are secure.
• Ensure movement detectors are not obstructed.
Enter: User code and press A.
If groups are enabled and a user has group choice, then the group status is displayed on screen. Each group
has a letter under it to display the status of the group as follows:
R = Ready
S (steady) = Set
S (flashing) = Selected for setting
U = Unset
Pressing the group number will allow the status of the group to be toggled. The current state is shown steady.
The new state is shown as flashing.
Once the required groups have been enabled press the ent key to begin the setting procedure.
If groups are not enabled and the user does not have group choice, entering the user code followed by A
immediately starts the setting procedure.
The keypad displays the exit time countdown. At the end of the exit time, or when the setting procedure is
terminated by a FINAL or PUSH-SET zone closing, the ENTRY/EXIT HORN outputs and keypad buzz-
ers become silent for four seconds, then emit two long tones to confirm that the system is set. The message
SYSTEM IS NOW SET appears for five seconds on the keypad that the user has logged into only. All other
keypads remain at the banner.

Part Setting

Enter: User code and press B.
Press 1 = Part Set
This is identical to the Full Setting procedure, except the keypad display indicates that the system is being
Part Set. Only the zones which have the Part attribute enabled (refer to option 52.1.2 =
ZONES.Function.Part Set), are included.
S E T S E T S E T 1 2 3 1 2 3 1 2 3
S E T S E T 1 2 3 1 2 3
GROUPS SSR GROUPS SSR GROUPS SSR GROUPS SSR GROUPS SSR
FULL SET FULL SET FULL SET FULL SET FULL SET 060 060 060 060 060
PART SET PART SET 060 060
PART SET PART SET PART SET 060 060 060
41
Setting Options