Honeywell Galaxy 2 Series Installation Manual page 83

Galaxy 2 Series Installation Manual
52 - Zones (cont'd)
17 Link
This has no alarm function but can be used to activate links.
18 Spare
The Spare function allows any zones that are not being used to be ignored by the system; the resistance
readings from the circuit - including the tamper conditions - do not activate an alarm condition.
NOTE: It is recommended that all unused zones are programmed as Spare and that a 1kΩ 1% resistor is
connected across each of these zones.
19 Fire
The Fire function is continuously operational. When activated, a FIRE zone overrides the Bell Delay pa-
rameter and activates an instant alarm (Bell, Strobe and Fire). The keypad buzzer and control panel horn
output, if fitted, emit an interrupted tone (one second on, 0.5 seconds OFF), easily distinguishable from all
other alarm conditions. Any valid code entry cancels the Fire activation.
20 Tamper
The Tamper function is continuously operational. When a Tamper zone is activated (1kΩ to 2kΩ), a tamper
alarm is generated; this requires to be reset by an authorised user code. If a tamper condition (open or short
circuit) occurs, a tamper alarm is also generated.
23 Batt Fail
This function is used to monitor the voltage of a back-up battery connected to a power supply. It causes an
Aux. Power Supply fault condition.
25 AC Fail
This function is used to monitor a remote power supply. In the event of a power failure the AC Fail zone is
activated; the activation (+) and de-activation (–) of the zone is recorded in the event log.
53 Secondary Entry
As exit function but changes to entry upon the force omitting of a final zone.
54 Assistance
This function activates a "personal assistance required" alarm in both set and unset conditions. Bells and
sounders are activated and an assistance message is signalled.
55 Bell Fail
This function causes a bell fault condition.
75