Resetting An Activated Smoke Detector; Remote Phone Access - Honeywell Apex Destiny 4100 User Manual

RESETTIN G A N
A C TIV ATED
SM O KE
DETE C T O R
REM O TE
PH O NE
A C C ESS
N O TE:
14
RESETTIN G A N A C TIV ATED SM O KE
DETE C T O R
Whenever any of your wired (non-battery powered) smoke
detectors activate the system, they will latch “ON” until
you reset them. To do so, enter your primary code fol-
lowed by 6. The system will say “SMOKE POWER”.
REM O TE PH O NE A C C ESS
You can gain access to the system from any touch-tone
phone when you are away from home. If you use an
answering machine, your installer will program an
override digit which you will use to bypass the answer-
ing machine and get directly into the system.
Following is a step-by-step description of phone access:
1. Dial your home number from any touch-tone phone.
2. The system will answer after a programmed number
of rings and you will hear an acknowledgment tone
that your system is ready and waiting. If you have an
answering machine, wait for it to answer, then press
the programmed override digit within 10 seconds
and you will then hear the acknowledgment tone
indicating that your system is ready and waiting.
3. You must now enter your disarm code and the
system will “speak” your system status. If you do not
enter an acceptable code within 5 seconds of the
tone you heard in Step 2, the system will automati-
cally hang up.
4. Now that you have entered your code and have
received the system status, your telephone can be
used as a keypad. To hear the status of your system
again, press the first digit of your disarm code and
wait three seconds. The system status will be
repeated through your telephone receiver.
To disarm the system over the phone, simply enter your
disarm code on the telephone keypad. To arm the
*
system, use the
to arm to HOME. Once you have finished, simply hang
up the phone and the system will hang up at the other
end. If you do not press any digits for a period of 15
seconds, the system will automatically hang up.
NOTE: Your installer can increase or decrease this time.
key to arm to AWAY or use the # key