Safety Precautions; A.4 Safety Precautions - Image Access WideTEK 36C Operation Manual

A.4

Safety Precautions

Warning: Please read all the safety precautions before you operate the scanner. Serious
injury can occur to you or to others if you do not know how to use it safely.
To prevent fire or shock hazard, do not expose this device to rain
or any type of moisture.
Danger of moving transmission parts when opening the upper
unit of the scanner.
This device is not suitable for use in locations where children are
likely to be present.
Follow all safety precautions to avoid personal injury or damage to the device.
1. Place the scanner in a clean, well-ventilated room. Do not operate the scanner in an
area with poor ventilation.
2. Openings in the scanner's housing in the front or at the back are provided for air
circulation. Do not cover or block the openings.
3. Do not place the scanner near a heat or cold emitting source such as a space heater,
furnace, or air conditioning unit.
4. Do not place the scanner near any devices or electrical boxes emitting high voltage.
5. Always place the scanner on a stable surface.
6. Do not place objects containing liquids on the scanner. If liquid spills into the scanner
it can cause damage. If this occurs, turn the scanner off and unplug the external
power supply. Contact the Image Access Technical Support.
7. Do not put any objects into any scanner housing openings unless specifically
instructed to do so by Image Access Technical Support.
8. Do not disassemble the scanner. If there is a need to disassemble the scanner,
please contact the Image Access Technical Support.
9. Do not use the scanner if it has been physically damaged. If this occurs, turn the
scanner off, unplug the external power supply and contact the Image Access
Technical Support.
10. The scanner should be used only with the external power supply that is delivered with
the scanner. If you have any question about the power supply, please contact the
Image Access Technical Support.
11. Before cleaning the scanner turn the power off and unplug the external power supply.
12. When cleaning, only use Image Access-approved cleaners. Do not use any type of
solutions, abrasives, or acids such as acetone, benzene, kerosene, mineral spirits,
ammonia, or nitric acid. Do not use any cleaners that contain these chemicals.
13. Use a dry or damp lint free cloth for cleaning the scanner.
14. Do not spray any liquids directly onto the scanner. Spray cleaning fluids directly onto
the cleaning cloth and use the cloth to clean the scanner.
Manual Page 17