Before Making Copies
1.3
Turning on the main power and the sub power
This machine has two power controls: the main power switch and the sub power switch.
1.3.1
Turning on the machine
The main power switch turns on/off all functions of the machine. Normally, the main power switch is turned
on.
The sub power switch turns on/off machine operations, for example, for copying, printing or scanning. When
the sub power switch is turned off, the machine enters a state where it conserves energy.
1
Open the front door, and then set the main power switch to "n".
2
Close the front door.
3
Press the sub power switch.
Check that the touch panel is turned on.
!
Detail
When the sub power switch is turned on, the indicator on the [Start] key lights up in orange, and a
screen indicating that the machine is starting up appears.
After a few seconds, the message "Warming up. Ready to scan." appears on the touch panel, and the
indicator on the [Start] key lights up in blue, indicating that a job can now be queued.
The default settings are the settings that are selected immediately after the machine is turned on (the
power switch is set to "n") and before any setting is specified from the control panel or touch panel, and
those that are selected when the [Reset] key is pressed to cancel all settings specified from the control
panel or touch panel. The default settings can be changed. For more details, refer to
Settings" on page
The factory default settings are the settings that were selected when this machine was sent from the
factory.
501/421/361
11-17.
1
"Custom Display
1-25