Konica Minolta bizhub 361 User Manual page 486

Authentication Unit (IC Card Type AU-201)
Registering users
Reminder
In order to register users with Data Administrator, this device must be connected to the USB port of the
computer, and the computer and multifunctional product must be connected over a network.
Multifunctional product
1
If this device is connected to the multifunctional product, turn off the multifunctional product with the
main power switch, and then disconnect this device.
– If this device is connected to the computer, continue with step 4.
– When the multifunctional product is turned off, then on again with the main power switch, wait at
least 10 seconds to turn the machine on after turning it off. The machine may not operate correctly
if it is turned on immediately after being turned off.
– Hold the plug when plugging and unplugging the USB cable, otherwise the cable may be damaged.
2
Turn on the multifunctional product with the main power switch.
3
Connect this device to the USB port of the computer installed with Data Administrator.
– Do not connect other USB devices to the same port where this device is connected. If enough USB
power is not provided, this device may not operate correctly.
– When using a USB hub, be sure to use a self-powered USB hub that can provide 500 mA or more.
– After connecting this device, wait at least 5 seconds before operating it.
– If the data have already been read out, proceed to 7.
4
Find this device in the window, then double-click it.
501/421/361
Network
Computer
USB
This device
13
13-14