Default Settings; Save User Settings As Defaults; Restore User/Factory Defaults - CipherLab 1800 series Reference Manual

1800 Series Handheld RFID Reader Reference Manual

DEFAULT SETTINGS

SAVE USER SETTINGS AS DEFAULTS

For the RFID Reader to keep the customized settings as user defaults, you must issue
"#@sys_svusrtbl" command.
Note: After issuing the command, the current settings will be saved as user defaults.
Command:
#@sys_svusrtbl\r
Purpose Save User Defined Setting
Response OK\r
ERR,[code]\r

RESTORE USER/FACTORY DEFAULTS

For the RFID Reader to restore the User Defaults, which you have saved earlier, you
must issue the "#@sys_ldstbl=1" command. Alternatively, you can also issue the
"#@sys_ldstbl=0" command to restore Factory Default.
Command:
#@sys_ldstbl=[m]\r
Purpose Load Default Setting
Request #@sys_ldstbl=[m]\r
[m]: '0' – Factory Default
'1' – User Default
Response OK\r
ERR,[code]\r
Note: Restoring factory defaults may reset any active Bluetooth
the MAC address information of the connected device.
14
®
connections and erase