Table of Contents
Advertisement
Group1 System Status (Green LED1):
Press <F1>+<F2> to enter Group1 with Green LED1. In the Group1, you can press
<F1> to switch among Battery Status, Bluetooth
Space. After idling for 3-seconds timeout, the LED status will return to normal mode.
Power Level (Red LED)
Battery Empty
®
Bluetooth
Signal Strength (RSSI) (Blue LED)
Poor
Available Memory Capacity (Green LED)
Memory Full
Note: You must have an active Bluetooth
strength.
Group2 RFID Assistance (White LED1):
Press <F1>+<F2> to switch to Group2 with White LED1. The Group2 includes two
defined commands (Command1 and 2). Press <F2> to switch between Command1 and
Command2; press <F1> to execute the command. The LED status will return to normal
mode when you idle for about 3 seconds during configuration.
Command1: Set Single or Multi-Tag Scan Mode. With F1 pressed, two beeps with
tones ascend from low to high.
(As serial commands: "#@rf_scan=6" or "#@rf_scan=9")
Command2: Clear the tag list for Multi-Tag Scan Mode. With F1 pressed, two beeps
with tones ascend from low to high.
(As serial command: "#@rf_mtagcnt=")
Press <F2> to switch between Command 1 and 2 (each press two beeps with tones
ascending from low to high).
Command1
Chapter 1
®
Signal Quality, and Data Memory
®
connection to display the Bluetooth
Understanding RFID Reader
Full Battery
Very Good
Memory Empty
®
Command2
signal
33
Advertisement
Table of Contents
