Table of Contents
Advertisement
Purpose
Set the Separators of Each field in EPC Tag Data Section
Request
#@dat_ rfspr=[m],[n],[o],[p],[q]\r
[m]: input data format, '0'- in Hexadecimal, '1'- in character
[n]: separator between field1 and field2
[o]: separator between field2 and field3
[p]: separator between field3 and field4
[q]: separator between field4 and field5
Response
OK\r
ERR,[code]\r
Note: Input '00' (hexadecimal) to clear the inputted data.
Example:
Command
#@dat_rfspr?
Response (s)
OK,
Command
#@dat_rfsprh?
Response (s)
OK,00,00,00,00
21.
2012-04-12 Fri 04:00 55.95 34303331303031323030303030004221
Command
#@dat_rfsprh=0,2d,2d,2d,2d
Response (s)
OK
22.
2012-04-12 Fri 04:00 55.95 343033313030313230303030-3000-4221-
Command
#@dat_rfsprh=1,/,/,/,/
Response (s)
OK
23.
2012-04-12 Fri 04:00 55.95 343033313030313230303030/3000/4221/
Note: If a specific field is disabled, its following separator will be ignored.
Chapter 5
→ get the separators in character format
→ get the separators in hexadecimal format
→ reset the separators using hexadecimal format
e.g. 2d is specified for '-'
→ reset the separators using character format
DefinING Output Format
139
Advertisement
Table of Contents
