CipherLab 1800 series Reference Manual page 37

Command:
#@sys_txben?\r
Purpose Get Transmit Buffer Status
Response OK,[m],[n]\r
ERR,[code]\r
#@sys_txben=[m] {,[n]}\r
Purpose Enable Transmit Buffer
[m]: '0' – Disable (default)
'1' – Enable
'2' – Enable passive transmit buffer
[n]: '0' – Keep data until getting "clear buffer" command
'1' – Automatically clear the buffer after data sent (default)
[n] exists only when [m] is set to 2. When [m] is set to 0 or 1, [n] will be reset
to default.
Response OK\r
ERR,[code]\r
#@sys_txbdly?\r
Purpose Get Transmit Buffer Delay
Response OK,[m]\r
ERR,[code]\r
#@sys_txbdly=[m]\r
Purpose Set Transmit Buffer Delay
Request [m] Send TX Buffer Delay
'0'
'1'
'2'
'3'
'4'
'5'
'6'
'7'
Response OK\r
ERR,[code]\r
Chapter 1
0 (default)
250 ms
500 ms
1 sec
2 sec
3 sec
5 sec
8 sec
Understanding RFID Reader
25