Canon LBP7780CX User Manual page 601

[Substitute Size] [Off], [On]
[Special Image [Off], [Level 1],
Mode] [Level 2]
[SD Card Maintenance]
[Format] [No], [Yes]
[Special Print Mode]
[Curl Correction] [Off], [On]
[Smooth Plain
[Off], [On]
Paper]
[Update Firmware]
[USB]
[Network]
[Off], [After
[First Calibration] Jobs],
[Immediately]
[Paper Feed
Method]
Size of the Paper to Be Printed
If the centers of dense text or lines are not being printed, set this to [Level
1].
If the problem still persists after setting it to [Level 1], set it to [Level 2].
When [Special Image Mode] is used, the print density becomes
lower.
Delete the contents of the SD card.
When printed paper curls, set this item to [On].
If plain paper with a smooth surface is used, the density may be low. In
such a case, set this item to [On] to improve this problem.
Normally, use the printer with this option set to [Off]. Change the
setting for this option only if the above phenomenon occurs.
This option is to be executed only when the firmware of the printer needs
to be updated.
Specify the timing of calibration.
If [After Jobs] is specified, calibration is performed at the completion of the
first printing after the printer is turned on.
If [Immediately] is specified, calibration is performed immediately after the
printer is turned on.
When calibration is performed immediately after the printer is
turned on, excessive time is required until the printer is ready to
print.
"Automatically Performing Calibration Immediately after the Printer Is
Turned ON"
Specifies on which side of the loaded paper the printer should print.
Perform printing after selecting the paper drawer or tray to feed paper.
Select the paper source.
"[Setup] Menu ([Paper Source] Options)"
The setting of this item determines which side of paper is printed on. Load
the paper in proper orientation.
[Multi-
"Paper Loading Orientation"
Purpose
If [Speed Priority] is specified, the printing sides of the paper for 1-
Tray]:
sided printing and 2-sided printing do not match.
[Speed
Priority],
[Print Side
Priority]
[Drawer 1]:
[Speed
Priority],
[Print Side
If you specify [Print Side Priority], the printer matches the printing
Priority]
sides of the paper for 1-sided printing and 2-sided printing.
*
Therefore, when you print previously printed paper, you do not need
[Drawer 2] :
to reload the paper each time you switch between the settings.
[Speed
Letter
A4
Printer Driver Setting
A4
Letter