Canon LBP7780CX User Manual page 437

the one that has been used is assigned.
When using DHCP, consult your network administrator and perform either of the following settings.
Specifying the DNS Dynamic Update function
"Configuring the Protocol
Specifying the settings so that the same IP address is always assigned when the printer starts up
3. Set the IP address, the subnet mask, and the gateway address manually as needed.
When setting them manually, go back up the hierarchy by pressing [
procedure in "If You Selected [Manual] in Step
Even if you are using any one of DHCP, BOOTP, or RARP, specify the IP address, subnet mask, and
gateway address. If you cannot obtain information from the servers of DHCP, BOOTP, and RARP, the values
specified manually are used.
NOTE
When using DHCP, BOOTP, or RARP
You can select only one from RARP, BOOTP, or DHCP.
After the printer restarts, the values obtained from DHCP, BOOTP, and RARP are displayed.
(If the values were specified previously, they overwrite the obtained ones.)
4. Proceed to Step 7.
If You Selected [Manual] in Step 5
1. Select [IP Address Settings] using [
2. Select [IP Address], [Subnet Mask] and [Gateway Address] using [
3. [IP Address], [Subnet Mask] and [Gateway Address] are each set.
NOTE
How to enter values in [IP Address], [Subnet Mask] and [Gateway Address].
1. Press [
three-digit numbers) in which you want to enter respective values of the address.
(The numbers in the field blinks, allowing you to enter the value.)
2. Enter the value. (Pressing [
3. After entering values in all the fields, press [OK] to confirm the setting.
4. Proceed to Step 7.
7
Perform a hard reset or restart the printer.
After performing a hard reset or restarting the printer, the settings are effective.
NOTE
For details on a hard reset
See "Canceling All the Jobs (Hard
Settings"
5."
] and [
] and [ ] to move the cursor to each field (an area separated by periods to enter
] increases the value and [
Reset)."
] ( : Back), and then perform the
], and then press [OK].
] decreases the value.)
] and [ ], press [OK].