Canon LBP7780CX User Manual page 591

Proxy], [Do Not Use
Proxy]
*
[Proxy Settings]
[Proxy
Authentication]
[Off], [On]
[User Name]
[Password]
[SNTP] [Off], [On]
[Discovery
[Off], [On]
Response]
[IPSec] [Off], [On]
[NetWare]: [Off], [On]
[Frame Type]
Detect], [Ethernet
II], [Ethernet 802.2],
[Ethernet 802.3],
[NetWare Settings]
[Ethernet SNAP]
[Print Service]
[Bindery PServer],
[RPrinter], [NDS
PServer], [NPrinter]
[AppleTalk] [Off], [On]
[SMB Server]: [Off],
[On]
*
[SMB]
[SMB Print]: [Off],
[On]
[SNMP Settings]
[SNMP v. 1 Settings]
[SNMP v. 1] [Off], [On]
[Dctd. Community]:
[Dctd.
[Off], [Read/Write],
Community Set.]
[Read Only]
[SNMP v. 3]: [Off],
[On]
[User Settings 1] to
[SNMP v. 3
[User Settings 5]
specify [Use Proxy].
*
If you want to use the proxy authentication function, specify [On].
:
Enter the user name to be used for the proxy authentication. Up to
*
: -
24 alphanumeric characters can be entered.
Enter the password to be used for the proxy authentication. Up to 24
*
: -
alphanumeric characters can be entered.
When obtaining time using the SNTP Client function, specify [On].
*
Specify the settings for [NTP Server Name] and [Polling
Interval] from the Remote UI.
"Configuring the Protocol Settings"
If you want to set the printer so that it responds to searches that used
the multicast discovery function, specify [On].
*
Specify the setting for [Scope Name] from the Remote UI.
"Configuring the Protocol Settings"
When using the IPSec function, set it to [On].
"Setting the IPSec Encryption Communication Function "
*
: [Auto
Configures the NetWare network settings.
"Configuring the Protocol Settings"
*
:
Specifies whether the printer should use AppleTalk.
"Configuring the Protocol Settings"
Specifies whether the printer should use SMB.
"Network Settings for the Printer (SMB) "
Specify the settings related to SNMP protocol.
"Restricting the Users Who Can Monitor/Change the Settings
Using the SNMP Protocol"
Specify the settings related to SNMP v. 1 protocol.
Specify whether to use the SNMP v. 1 protocol.
[Dctd. Community] specifies whether to permit accessing to the
Management Information Base (MIB) that SNMP manages using the
name of dedicated community for Canon equipment.
To use Canon utility software, it may be necessary to select
[Read/Write].
*
:
Specify the settings related to SNMP v. 3 protocol.