Canon LBP7780CX User Manual page 592

Settings]
[Rjct Packet in
Sleep]
*
[Spooler]
[Network Delay
Time]
[Remote UI
Settings]
[Ethernet Driver]
[IEEE802.1X]
[Address Filter]
[MAC Address]
[E-Mail Print Set.]
[Init. Network Set.]
Method for entering addresses
1. Move the cursor to each field (an area separated by periods to enter three-digit numbers) in which you want to enter
the address, by pressing [
2. Enter the numbers. ([
3. After entering values in all the fields, press [OK] to confirm the settings.
[Auth. Password]
[Encryption
Password]
[Off], [On]
[Off], [On]
0 to 300 seconds
[Remote UI]: [Off],
[On]
* *
[SSL] : [Off], [On]
[Auto Detect]: [Off],
[On]
[Communication
*
Mode] : [Half
Duplex], [Full
Duplex]
*
[Ethernet Type] : [10
Base-T], [100 Base-
TX], [1000 Base-T]
[Off], [On]
[Off],[On]
(Display only)
[POP3 RX Interval]: 0
to 90 (minutes)
[POP3 RX]: [Off],
[On]
[SMTP RX]: [Off],
[On]
] or [ ]. (The number in the field blinks, allowing you to enter a value.)
] increases the value and [
Specifies whether to discard the SNMP packets received while in
sleep mode.
If you set this item to [On], you may be unable to access the
printer from Canon software (iW Series) or applications using
the SNMP protocol.
When using the spooling function, set it to [On].
"Setting the Spooling Function "
Specifies the time interval from when the printer is turned ON to
when the protocol starts.
"Specifying the Setting for Startup Waiting Time"
Specifies whether the printer should use the Remote UI.
Also, whether to use SSL for communication by the Remote UI is
specified.
"Setting Keys and Certificates"
Configures the Ethernet driver.
"Changing the Network Transmission Speed or Transfer Mode"
When using the IEEE802.1X function, set it to [On].
"Setting IEEE802.1X Authentication"
When using the address filter function, set it to [On].
"Restricting the Users Who Can Print or Perform the Printer
Settings"
"Restricting the Users Who Can Access"
Displays the MAC address of the printer.
Set e-mail print.
When [POP3 RX Interval] is changed from 0 minute, POP3
reception immediately after the setting has been changed is
performed at a specified interval plus approximately five
seconds. From the second time onwards, POP3 reception is
performed at a specified interval.
"Receiving E-mail Data on the Mail Server and Printing (E-mail
Print)"
By the initialization in this item, you can reset the network settings to
the default settings.
"Initializing the Network Settings"
] decreases the value.)