Apply The Decals; Installing The Receiver - Seagull Models ISPORTS 10cc Assembly Manual

ISPORT 10-15cc

APPLY THE DECALS.

1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and
aid in their location.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.

INSTALLING THE RECEIVER.

1) Plug the five servo leads and the switch
lead into the receiver. Plug the battery
pack lead into the switch also.
2) Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.
3) Route the antenna in the antenna tube
inside the fuselage and secure it to the
bottom of fuselage using a plastic tape.
Battery.
ATTACHMENT WING- FUSELAGE.
Attach the aluminium tube into fuselage.
26
Receiver.
Instruction Manual.
Insert two wing panels as pictures below.
Wing tube.
Wing bolt.
4x20mm.