Seagull Models ISPORTS 10cc Assembly Manual page 11

Thread locker glue.
C/A glue.
M4x20mm
WHEELS AND WHEEL PANTS.
1) Locate the items neccessary to install
2) Follow diagram below for wheel pant
installation:
Use a drill and 8mm drill bit to drill a
hole in the wheel pants.
WWW.SEAGULLMODELS.COM
M4x20mm
Drill a hole.
8mm.
14mm.
3) You have to trim each axle using a tool
cutting and cut-off wheel.
4) Slide the collar to the axle and setscrew
the collars to secure the collar to the axle
and then slider the wheel on the axle with
a drop of oil on the axle so the wheel will
spin freely when installed. Prepare a sec-
ond collar and tighten the setscrew using
hex wrench to secure the collar to the
axle.
5) Place the wheel assembly in the wheel
pants. The threaded portion of the axle
will fit the notch of the wheel pant as
shown.
Wheel collar.
Axle.
Washer.
Washer.
nut.--
Wheel Pant.
C/A glue.
M3
M3
Wheel.
Wheel collar.
Wheel.
Axle.
M3.
Lite-Plywood
block.
11