Table of Contents
Advertisement
MH-5000 User Manual
Step 10. Customize the rule
Check the Active checkbox. Enter a name for this
rule like IKErule. Enter the Local IP Address
(192.168.40.0/255.255.255.0) and the Remote IP
Address (192.168.88.0/255.255.255.0). Select
the Outgoing Interface of this Device. Select
Dynamic IP in the Peer's IP Address. Be sure to
select Aggressive mode for the dynamic remote
gateway address type. Click the ESP Algorithm
and select Encrypt and Authenticate (DES, MD5).
Enter the Pre-Shared Key as 1234567890. Click
the Apply button to store the settings. Note, In the
Action region. It should choose either ESP
Algorithm or AH Algorithm, or system will show
error message. If you hope to set the detailed
item of IKE parameter. Click the Advanced button
in this page. Otherwise it is ok to just leave the
value default.
Note that Peers Identifier must NOT be IP
Address type in the Dynamic IP type. So, you
have to select FQDN (domain name) or user
FQDN (mailbox) as the Peer's Identifier.
ADVANCED SETTINGS > VPN Settings > IPSec > IKE > Add
Self local IP
Address
The opposite
side IP Address
90
Virtual Private Network –Dynamic IPSec
Chapter 11
Advertisement
Table of Contents
