Network Configuration Summary; Ethernet Test - Radyne DMD2050 Operation Manual

DMD2050 Universal Satellite Modem
8. MODEM EADDR: This displays the Modem (Unit) Ethernet Address. The Modem
Ethernet Address is configured at the factory. It is a unique Radyne equipment identifier
Address. Example: 0010650903EB
9. ETHER RATE: This displays the current Ethernet port data rate. If multiple rates are
available, then a selection can be made to specify the Ethernet port data rate (10BaseT).
Example Ethernet port Data Rate: 10 MBPS/HD
F.2

Network Configuration Summary

If the above steps were followed and the information was entered, then the following would be the
TCP / IP configuration summary for a 'no router specified' setup:
1. Boot Mode =
2. Bootp Server Tag =
3. Modem Host=
4. IP Address Mask =
5. Modem IP Address =
6. Server IP Address =
7. Router IP Address =
8. Modem Ethernet Address= 0010650903EB
9. Ethernet Rate =
F.3

Ethernet Test

Connecting the Modem Ethernet Cable to a Network Link
1. Connect the Network Switch (Hub) to the Modem Ethernet port (J9) using
standard RJ-45 to RJ-45 10BaseT (CAT-5) Cables as shown below.
Connecting the Modem Ethernet Cable Directly to a Computer (without a Network)
The user can directly connect to the equipment without connecting to a network. This will often
occur at remote sites where a network is not available. To connect, the user will need an
Ethernet Crossover (Null) cable. The pinout for this cable is as follows,
TM110 – Rev. 1.3
NON-VOL
206
DMD20
255.255.0.0
172.18.100.215
172.18.4.250
010.000.001.001
10 MBPS/HD
DMD20 Ethernet Network Connection
RJ45 Connector A RJ45 Connector B
Pin #1
Pin #2
Pin #3
Pin #4
Pin #5
Pin #6
Pin #7
Pin #8
Pin #3
Pin #6
Pin #1
Pin #4
Pin #5
Pin #2
Pin #7
Pin #8
Appendix F
F
-3