Table of Contents
Advertisement
OM20 Universal Outdoor Modem
The modem offers addition features that allow for specific administrative
privileges for various users. Please refer to section 3.3 for additional
information.
This concludes the initial set up that will allow the user full access to the modem. In the event that
the user needs to change the IP Addressing to support a different network then proceed to
section 3.1.
D.3.
IP Network Change from the Initial Web Setup
D.3.1 Configuring the modem
This section is a continuation from the initial setup or can be used on an existing system that
requires a network setup change. The modem needs to be configured with the correct network
settings. Please consult with your IT manager for an IP address mask, and modem, server, and
router IP addresses valid for your network. To recognize a subnet, each system in the subnet
must have the same subnet mask. This field should be set before changes are made to the
Modem or Router Address. Refer to Figure 5.
1. Configure the modem first with the new subnet addresses. From the modem introduction
page, click the IP ADMINISTRATION tab located on the top of the screen.
2. Enter your username and password on the logon popup, and then press the Enter key.
3. Change the Boot Mode to NON-VOL. Change IP addresses, and subnet mask to the
recommended settings and click on the Save button to accept the changes (refer to
section 3.2.2 for Boot Mode descriptions).
NOTE: NON-VOL: Stores and uses IP Mask and addresses as provided by the user.
4. Click on the Cancel button at any time to abort and reload the current modem IP network
settings.
TM116 – Rev. 1.2
Appendix D
D-
4
Advertisement
Table of Contents
