Installing Fuselage Servos; Throttle Servo Arm Installation; Install Rudder Control Horn - Seagull Models P47 SNAFU Instruction Manual

Elevator fiberglass control horn.

INSTALL RUDDER CONTROL HORN.

Repeat steps to install the rudder control
horn as same as steps done for ailerons.
Fiberglass control horn
Rudder fiberglass control horn.
WWW.SEAGULLMODELS.COM
Epoxy.
Epoxy.
INSTALLING THE FUSELAGE SERVOS.
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the
servo into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Throttle servo.
THROTTLE SERVO ARM
INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
Loctite secure.
Throttle servo arm.
.
Elevator servo.
Rudder servo.
Adjustable servo
connector.
Servo arm.
7