Installing Propeller - Seagull Models P47 SNAFU Instruction Manual

M3x15mm
Epoxy
145 mm
Balsa stick.
Epoxy
6) Attach the speed control to the side
of the motor box using two-sided tape
and tie wraps. Connect the appropriate
leads from the speed control to the mo-
tor. Make sure the leads will not interfere
with the operation of the motor.
Speed control
WWW.SEAGULLMODELS.COM
.
Tie wraps.
Battery.
INSTALLING THE PROPELLER.
The propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
19