Seagull Models P47 SNAFU Instruction Manual page 33

INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot,
.
seats.
2) A scale pilot is included with this ARF.
The Seagull Pilot included fitting well to
the cockpit. (or you can order others scale
pilot figures made by Seagull factory.
They are available at Seagull distributors.)
If you are going to install a pilot figure,
please use a sanding bar to sand the base
of the figure so that it is flat.
33
WWW.SEAGULLMODELS.COM
3) Position the pilot figure on the canopy
floor as show. Locate the oval shaped on
the canopy floor and remove the cover-
ing. Use epoxy to glue this into the base
of the pilot figure and glue the cockpit
panel in place with C/A glue, please see
pictures as shown.
10mm
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the
fuselage using a felt-tipped pen.
Wing bolt.
Epoxy.
C/A glue.
33