Seagull Models P47 SNAFU Instruction Manual page 30

P47 SNAFU
2) Install the elevator control horn using
the same method as with the aileron con-
trol horns.
3) Position the elevator control horn on
the both side of elevator.
Elevator control horn.
3) Thread one clevis and M2 lock nut on
to each elevator control rod. Thread the
horns on until they are flush with the ends
of the control rods.
4) Elevator and rudder pushrods assem-
bly as pictures below.
M2 clevis. M2 lock nut.
M2 clevis.
Fuel tubing.
30
Elevator pushrod.
Hex nut.
Instruction Manual.
RUDDER PUSHROD HORN
INSTALLATION.
1) Locate items necessaryto install rud-
der pushrod.
Elevator control horn.
Rudder control horn.
Rudder pushrod.
50mm