Table of Contents
Advertisement
Original Orientation
In order to identify the top of the document, the orientation of the set document must
be configured.
Note
Upright Images
Select this item when placing the top of the document facing the inner side of the
document glass or document feeder.
Sideway Images
Select this item when placing the top of the document facing the left side of the
document glass or document feeder. Be sure to select [Sideway Images] when the
top of the document is placed facing the left side (horizontal text).
[Delete Outside/Delete Inside - Area X] screen
Set the area to delete outside of or inside of. The quadrangle with a diagonal line and
4 straight sides connecting the coordinates, X1/Y1 and X2/Y2 is a deleted or extracted
area. By making the top right corner of a document into the starting point, the X-axis is
set as the direction of width, and the Y-axis is set as the direction of length.
You can specify a value within the range of 0 to 432 mm for the width (X) and the length
(Y) in 1 mm increments.
Note
1
Select [Area 1].
2
Enter the value for X1 in [X1] using
the numeric keypad, and select
[Next].
3
Enter the value for Y1 in [Y1] using
the numeric keypad, and select
[Next].
4
Enter the value for X2 in [X2] using
the numeric keypad, and select
[Next].
5
Enter the value for Y2 in [Y2] using the numeric keypad, and select [Next].
Note
Clear Area X
Clear the specified area.
Next
The
mark moves to the next coordinate.
• If the [Original Orientation] differs from the actual document orientation, then the machine
may mistakenly detect the head of the document.
• Specify the 2 coordinates from the top right corner of the document.
• When specifying multiple areas, the specified areas can overlap each other.
• When [Reduce/Enlarge] is enabled, the specified area will be reduced/enlarged accordingly.
• To change the coordinates you have entered, select [Next], move
value again.
• If all of [X1], [Y1], [X2], and [Y2] are set to [0], the area will be invalid. If no other area is
specified, the Delete Outside/Delete Inside feature cannot be used.
• If you select <C> button, values that the
, and then enter the
mark indicates is cleared.
Job Assembly
3
111
Advertisement
Table of Contents
