Table of Contents
Advertisement
Chapter Start...
Displays the [Build Job - Chapter Start] screen.
Refer to "[Build Job - Separators] Screen" (P.105).
Insert Separators...
Displays the [Build Job - Separators] screen.
Refer to "[Build Job - Separators] Screen" (P.105).
Change Quantity...
Displays the [Build Job - Change Quantity] screen. Enter a new quantity using the
numeric keypad.
Cancel
The document data stored by the Build Job feature is cleared and the job is cancelled.
Note
Last Original
Select this to end scanning of documents. The build job starts.
Next Original
Select this when you have another document. This item is selected when using the
Build Job feature.
Start
When loading the next document and select [Start], the next documents are scanned.
Note
Sample Set
When making multiple sets of copies, you can print a sample set to check the finished
output and then print the remaining copy sets. You can select to continue or cancel the
job after the confirmation.
[Build Job - Separators] Screen
You can insert a sheet of paper as a separator in between each stack of documents.
You can specify the number of separators to insert within the range of 1 to 99 as
necessary.
Note
1
Select any item.
2
Select [
keypad to enter the number of
separators to insert.
• The same operation is performed if you press the <C (Clear)> button or <Clear All> button
on the control panel.
• While scanning the loaded document, [Stop] is displayed. Select [Stop] to pause scanning.
Select [Start] in the touch screen, or press the <Start> button on the control panel to resume
scanning.
• The same operation is performed if you press the <Start> button on the control panel.
• : You can specify different settings for each stack of documents. If you do not specify
particular settings for each stack of documents, the previously specified settings are applied.
]/[
] or use the numeric
Job Assembly
3
105
Advertisement
Table of Contents
