Table of Contents
Advertisement
d. Set initial redial time. (There is one global setting for all remotes that report to the DAC-P. Range: 30 seconds to 5
minutes.)
e. Set fallback redial time. (Must be the same as initial redial time.)
f. Set redial attempts before fallback to three attempts.
g. Set primary phone number.
h. Set backup phone number.
i. Set all other phone number fields to none.
5. Send pending relay control commands.
6. If reboot requested, send reboot command.
7. Disconnect.
5
Installation
5.1
Tools Needed
To install the DAC-P, you'll need the following tools:
Phillips Screwdriver
Wire Strippers/Cutter
Small Standard No. 2 Screwdriver
Computer
5
Advertisement
Table of Contents
Need help?
Do you have a question about the DAC-P and is the answer not in the manual?
Questions and answers