Table of Contents
Advertisement
28
7.5
Reboot RTU
Fig. 29. Rebooting a remote from the DAC-P.
The C)onfig > M)onitor > R)eboot RTU command initiates a call to a remote and sends it a reboot command. If you choose
this command you will be prompted to enter the MEFA of the remote you want to reboot. A successful reboot will look like
Figure 29, above.
Note: After sending a reboot command, pressing the Esc key will exit to the Monitor menu, but it will not cancel the
transmission of the reboot command, which will proceed even if the call is not monitored.
Advertisement
Table of Contents
Need help?
Do you have a question about the DAC-P and is the answer not in the manual?