Table of Contents
Advertisement
CONTROL SYSTEM
ADJUSTING THE THROTTLE CONTROL
CABLE (F8CW)
NOTE:
Before adjusting the throttle control cable,
make sure that the shift control cable is
properly adjusted
1. Check:
Throttle control cable
Damage
Excessive slack or the stoppers do
not contact each other
2. Adjust:
Throttle control cable
Adjusting steps:
(1)Set the remote control lever to the
neutral position.
(2)Loosen the locknut 1 and remove the
clip and the cable end 2 from the
pulley 3.
(3)Move the pulley 3 by hand until the
stopper portion
contacts the stopper portion
throttle wire stay 4. Then, hold it in
this position.
(4)Turn the cable end 2 so it aligns with
the pin on the pulley 3.
Then, reinstall the cable end 2 onto
the pulley 3.
WARNING
The cable end should be screwed in more
than 8 mm (0.31 in).
(5)Install the clip and tighten locknut 1.
(6)Fully open and close the remote
control lever and make sure the
stopper portion
b
portion
position), and the stopper portion
contacts the stopper portion
fully-closed position).
If proper contact is not made, repeat
the above procedure.
NOTE:
If the throttle control cable cannot be
properly adjusted at the engine side, make
adjustment at the remote control lever
side.
3-7
Replace.
Adjust.
c
on the pully 3
d
a
contacts the stopper
(at the fully-opened
d
on the
c
(at the
Advertisement
Table of Contents
