Table of Contents
Advertisement
MANUAL STARTER
5. Set:
Starter spring
Setting steps:
(1)Place the starter wire 2 at the cutaway
a
of the sheave drum 3.
(2)Wind the sheave drum 3 5 turns
counterclockwise with the starter wire
2.
(3)Remove starter wire 2 from cutaway
a
, then wind on sheave drum 3.
6. Check:
Manual starter operation
Rough operation
NOTE:
When checking the manual starter only,
release the start-in-gear protection device.
5-8
Repair.
Advertisement
Table of Contents
