Table of Contents
Advertisement
POWER UNIT
3. Adjust:
Intake valve clearance
Exhaust valve clearance
Adjusting steps:
(1)Loosen the locknut 8.
(2)Turn the adjusting screw 9 in or out
until the specified valve clearance is
obtained.
(3)Tighten the locknut 8.
Locknut:
8 N
m (0.8 kgf
(4)Perform the above steps for all valves
which clearance are out of
specification.
4. Recheck:
Intake valve clearance
Exhaust valve clearance
NOTE:
If any valve clearance is still out of
specification, repeat all of the valve
clearance adjustment steps until the
specified clearance is obtained.
5. Install:
Cylinder head cover 4
Fuel pump 3
Dust cover 2
Recoil starter 1
NOTE:
Tighten the cylinder head cover bolt in
sequence.
3-16
a
b
m, 5.9 ft
lb)
a
b
Advertisement
Table of Contents
