Adjusting The Throttle Cable And Throttle Link - Yamaha F4B Service Manual

3. Install the shorter cable f to the section
a of the bracket g.
4. Install the throttle cable h, and then
tighten the locknuts b to the specified
torque.
h
b
a
Throttle cable locknut b:
4 N·m (0.4 kgf·m, 3.0 ft·lb)
5. Install the throttle link rod i and cap j,
and then tighten the throttle link screw k
to the specified torque.
k
j
Throttle link screw k:
1.5 N·m (0.15 kgf·m, 1.11 ft·lb)
Adjusting the throttle cable and
throttle link
1. Loosen the locknuts a.
2. Turn the throttle grip to the fully open
position.
3. Adjust the length of cable a so that the
stopper b of the throttle cam b contacts
section c of the bracket c.
g
f
i
a
a
a
4. Adjust the length of cable d so that there
is no clearance between the cable end d
and the section e of the throttle cam b.
d
5. Check that the section b on the throttle
cam contacts stopper c when the
throttle grip is in the fully open position,
and that the section b contacts stopper
f when the throttle grip is in the fully
closed position.
f
6. Tighten the throttle cable locknuts a to
the specified torque.
Intake silencer
b
c
c
b
b
d
e
c
b
6-14
0
1
2
3
4
5
6
7
8
9
10
A