Table of Contents
Advertisement
The Fusion LTE Web interface is divided into two sections. On the left is the main navigation panel (shown in Figure 9). On
the right is the content area for the desired page.
2.6
LTE CONNECTION
Before you begin this step, you will need an LTE contract with a carrier and an active SIM card.
On the left side of the screen, select WWAN0. This will bring up the WWAN0 status page. Select the Carrier Settings tab.
On the Carrier Settings page, enable the Interface and Provider #1 (If not done by default). You will have to hit save after
each change.
The APN, User and Password should be left blank unless you have received specific values from the Carrier. In most cases,
Authentication should be left as Any.
It may take several minutes to establish the connection after it has been enabled for the first time. Verify the connection is
active by click on the Status tab. See below.
20
Advertisement
Table of Contents
