CalAmp Fusion LTE User Manual page 30

Select LAN if this Ethernet port is connecting to a local area network. Select WAN if the Fusion is connecting to a
wide area network through an external router or gateway
IP Configuration
•
IP Address/Subnet Mask:
Same as in previous section
•
MTU:
Maximum Transmission Unit, max packet size allowed to be transmitted, should be left as default in most cases.
DHCP Server Configuration
•
DHCP Server:
When enabled, the DHCP server will assign IP address to a device or devices connected to the Ethernet port. IP
addresses assigned will be in the defined range (see below) and on the same subnet as the Fusion.
•
Dynamic Leases (Start IP Address/End IP Address):
External LAN devices connected to the Fusion will be assigned IP address in this range when DHCP is enabled. This
range of IP addresses must be on the same subnet as Fusion.
ETH Configured as a WAN
IP Configuration
•
Mode
30