Antenna - CalAmp Fusion LTE User Manual

Normal power-up sequence
The LEDs will act differently during boot up than during normal operation.
Step Action
1 Apply power to the unit.
2 Internal 5-volts power supply turns-on
3 Internal 1.8-volt and 3.3-volts power supply turn-on
4 Hardware initialization completed
5 Bootstrap program runs
6 Application starts
7 Application runs normally
1.8

ANTENNA

LTE antenna connections are SMA female connectors and must be used with antenna with SMA male connectors. When
using a direct mount or rubber duck antenna, choose the antenna specific to your band requirements. Mounting options
and cable lengths are user's choice and application specific. Each WWAN interface supports a primary and diversity antenna
connector.
Connect an active 3-5.5V GPS antenna, with an average gain >-5dBi, if using the GPS functionality.
Fusion is available with WiFi options, using RP-SMA connectors. Depending on the model, connect each WiFi antenna to the
proper connector. If equipped with a simple non-MIMO WiFi option, connect the primary WiFi antenna to the connector
labeled "M'. For Fusions equipped with MIMO WiFi (2x2 or 3x3 MIMO), connect the WiFi antennas to any free RP-SMA
connector.
This device is factory configured with default settings and is ready to be customized via HTML.
LED activity
NA
PWR = RED during approx 1 second
Every INDICATOR (except those attached to Ethernet)
become AMBER during approx 400 ms
Every INDICATOR become OFF except PWR which remain
AMBER.
PWR blinks AMBER.
PWR becomes solid GREEN.
PWR is solid GREEN. STAT is solid GREEN
16