Wireless Settings; Ip Settings - CalAmp Fusion LTE User Manual

Table of Contents

Authentication: Security mode as set by the WiFi access point (WPA, WPA2, etc.)

Encryption: Data encryption method as set by the WiFi access point

Channel: Transmit and Receive channel, defined by the 802.11 specification. This is set by the access point.

Signal Quality: RF quality indicator

RSSI: Receive signal strength indicator

Noise Level: Measurement of the ambient noise in the frequency channel selected

Bit Rate: Over the air throughput measurement, this will be affected by the type of access point connected to (b,g,or n)

and the number of WiFi antennas (1-3) installed on the Fusion.

3.6.4 WIRELESS SETTINGS

This screen allows the user to setup access points that the WiFi client will connect to automatically. The parameters

entered on this screen are the same as the WiFi access point section, except when operating in the client mode, the

parameters must match what is entered on the access point for the WiFi client to connect successfully.

When entered, the access point will be listed in the access point table at the bottom of the screen.

Table of Contents