NETGEAR 7300 Series User Manual page 222

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
OSPF Admin Mode
ASBR Mode
RFC 1583 Compatibility Reflects whether 1583 compatibility is enabled or disabled. This
Default-metric
Source
Metric-value
Match-value
Type-value
Tag-value
Subnets
Distribute-list
Default-info originate
The information below will only be displayed if OSPF is enabled.
ABR Status
Exit Overflow Interval
External LSA count
External LSA Checksum A number which represents the sum of the LS checksums of
9-40
The administrative mode of OSPF in the router. This is a config-
ured value.
Reflects whether the ASBR mode is enabled or disabled. Enable
implies that the router is an autonomous system border router.
Router automatically becomes an ASBR when it is configured to
redistribute routes learnt from other protocol. The possible values
for the ASBR status is enabled (if the router is configured to re-
distribute routes learnt by other protocols) or disabled (if the
router is not configured for the same).
is a configured value.
RDefault value for redistributed routes.
Source protocol/routes that are being redistributed.
Metric of the routes being redistributed.
The criteria by which OSPF routes are redistributed into other
routing domains.
External Type 1 or External Type 2 routes.
Decimal value attached to each external route.
For redistributing routes into OSPF, the scope of redistribution
for the specified protocol.
TAccess list used to filter redistributed routes.
Indicates whether the default routes received from other source
protocols are advertised or not
Reflects the whether or not the router is an OSPF Area Border
Router.
The number of seconds that, after entering OverflowState, a
router will attempt to leave OverflowState.
The number of external (LS type 5) link-state advertisements in
the link-state database.
external link-state advertisements contained in the link-state data-
base.
202-10009-01_060204
Routing Commands