No Routing; Show Arp - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
The current value for this function is displayed under "show ip interface" labeled as "Routing
Mode".
Default
Format
Mode

no routing

This command disables routing for an interface.
The current value for this function is displayed under "show ip interface" labeled as "Routing
Mode".
Format
Mode

show arp

This command displays the Address Resolution Protocol (ARP) cache. The displayed results are
not the total ARP entries. To view the total ARP entries, the operator should view the
results in conjunction with the
Format
Mode
Age Time (seconds)
Response Time (seconds) Is the time it takes for an ARP request timeout. This value
Retries
Cache Size
Dynamic Renew Mode Displays whether the ARP component automatically attempts to
Total Entry Count Current / Peak Field listing the total entries in the ARP table and the
Routing Commands
Disabled
routing
Interface Config
no routing
Interface Config
results.
show arp switch
show arp
Privileged EXEC
Is the time it takes for an ARP entry to age out. This value was
configured into the unit. Age time is measured in seconds.
was configured into the unit. Response time is measured in sec-
onds.
Is the maximum number of times an ARP request is retried. This
value was configured into the unit.
Is the maximum number of entries in the ARP table. This value
was configured into the unit.
renew dynamic ARP entries when they age out.
peak entry count in the ARP table.
202-10009-01_060204
show arp
9-35