Table of Contents
Advertisement
Customizing the Telephone
Step by Step
>
05=Setup?
>
4=Function keys?
1=Non shifted keys?
>
31=Repertory dialing?
u
CL CS OK PA
120
•
The Clear control function within a string causes
each active call to be cleared down; any remaining
characters are processed in a new context (normally
"idle").
The Consult control function within a string causes
•
the current call to be held and the remaining charac-
ters to be interpreted as dialing digits.
•
The Pause control function at the beginning of the
string means that the string should only be sent as
DTMF digits. If another call is not connected, this
key is ignored. The length of the pause is then zero.
•
The Pause control function after the dialing digits
ensures that once the connection has been estab-
lished, a wait time of at least three seconds will be
set.
•
The Pause control function after DTMF digits caus-
es a wait time of at least three seconds plus 0.2 sec-
onds for each digit sent in the previous block.
•
If a string concludes with OK, the digits are sent
without having to wait for the user to press OK or
until a timeout occurs.
With the Repertory dialing function multiple function
keys can each be programmed with a specific repertory
dialing sequence.
:
Select and confirm.
>
:
Select and confirm.
>
Programming the first level:
:
Confirm. You are prompted to press a key.
>
Press the function key to be programmed (the associat-
ed LED blinks).
:
Select and confirm.
>
o
Enter the selection sequence to be saved.
v
You can use the
:
Confirm if the destination is complete.
When programming function keys on an optiPoint 420
or optiPoint self labeling key module the electronic
labeling function Label is displayed with the following
prompt:
u
v
and
keys to insert a function.
Advertisement
Table of Contents
