Table of Contents
Advertisement
Installation
This section describes installation of your server.
Tower Model
IMPORTANT:
Select a suitable location for the tower model.
Observe the following instructions to use this equipment safely. Failure to
follow these instructions could cause a burn, injury, or damage to physical
assets.
Do not lift the equipment alone.
Do not install the equipment in non-designated places.
Close enough to connect the
mouse and the display.
Floor or a level
and robust desk or
table.
Clean and tidy room
Place having a space enough to fully open
the front door (The front door extrudes about
50 mm from the right side of the server
when fully opened.)
Do not install the server in the locations listed below. Otherwise, the server may
malfunction.
!
A location where temperatures change widely (near a heater, air
conditioner, or refrigerator).
!
A location that is subject to intense vibration.
2-4 Setting Up the System
The server is a precision instrument. Handle it with care.
CAUTION
UPS to prevent momentary voltage drop due to power
failure or lightning *
* Optional. UPS is recommended for best use of
features of ft server.
A room that can maintain the following
conditions during operation:
Temperature: 10 to 35ºC
Humidity: 20 to 80% (non-condensing)
100V - 120 V parallel bi-
polar power outlet with
grounding
Wall outlet within the
reach of supplied power
cords.
* Use the server in a room where temperature can be kept
between 15 and 25ºC.
Advertisement
Table of Contents
Troubleshooting
