Moving System Jumpers - NEC EXPRESS 320Lb User Manual

Moving System Jumpers

Before doing the procedures in this section, make sure that
your system is powered off and unplug the AC power cords
from the back of the chassis. Failure to disconnect power
before moving the jumpers can result in personal injury and
equipment damage.
Observe static precautions. Use an antistatic wrist strap.
To configure the system jumpers on the PCI board:
1. Perform steps 1 through 5 of subsection Modifying the PCI Board in
chapter 4.
Note
module s.
2. Locate the position of the system jumpers that you are changing on the PCI
board. To change a jumper setting, use a pair of needle-nose pliers or your
fingers to remove the jumper from its current location, see Figure 3-2.
Position the jumper over the two pins for the desired setting and press it onto
the pins. Be careful not to bend the pins. Refer to Table 3-1 for system
jumper settings.
3. Perform steps 12 through 14 of subsection Modifying the PCI Board in
chapter 4.
3-24 Configuring Your System
! CAUTION
: Use the same jumper settings for both PCI
Figure 3-2 Moving a Jumper (Shorting Plug)