Monitoring Post - NEC EXPRESS 320Lb User Manual

Monitoring POST

Each time you turn on the system, the Power-On Self-Test (POST) runs automatically
and checks the CPU modules, PCI modules, keyboard, mouse, and most installed
peripheral devices.
During the memory test, POST displays the amount of memory that it is able to access
and test. Depending on the amount of memory, it may take several minutes to complete
the memory test. When the memory test completes, the following is displayed:
Press <F2> to enter SETUP
Press <F2> to enter BIOS SETUP. When the utility appears, follow the instructions on
your monitor to configure BIOS. See Chapter 3, "Configuring Your System." If you do
not press <F2>, the above message remains for a few seconds, the boot process
continues, and the system beeps once. Then this message appears:
Operating System not found
If you do not press <F2>, the boot process continues and this message appears:
Press <Alt Q> to enter Fast!Util
Press <Alt Q> if you want to configure SCSI devices in your system. When the utility
appears, follow the instructions on your monitor to configure the SCSI host adapter
settings and run the SCSI disk utilities. See Chapter3, Configuring Your System. If you
choose not to run Fast!Util
After POST completes, the system beeps once.
If POST finds an error, it displays an error message and, in case there is a problem with
the display, it emits a series of long and short beeps. Write down any beep code
emitted. This information is useful to your service representative.
Refer to the "Error Messages" section in this chapter for a list of items to check for each
error code and for an explanation of the error beep codes.
The POST Tests table at the end of this chapter lists keys active during POST and
provides a description of errors that may occur.
The BIOS indicates errors by writing an error code to the standard logging area in the
Extended BIOS Data Area, and by displaying a message on the screen, which is
sometimes preceded by the POST Error Code. The error code will also be logged to the
Event Logging area.
Report any error code to your service representative.
™
Utility!
™
Utility, the boot process continues.
Problem Solving 5-7