Thermal Sensor Submenu; Wake On Events Submenu; Console Redirection Submenu - NEC EXPRESS 320Lb User Manual

*Pressing the Power switch for at least 4 seconds shuts down power to the server.

Thermal Sensor Submenu

Feature
Thermal Sensor
Upper Limit
Lower Limit

Wake On Events Submenu

Feature
Wake On LAN

Console Redirection Submenu

Feature
Serial Port Address
Baud Rate
Flow Control
Console
Connection
Choices or
Display Only Description
Disabled When enabled determines if
Enabled the BIOS will disable boot (if
temperature is not within a
safe range).
7 – 48 - 80 Specifies the upper
temperature limit for bootup
restriction in Celsius. Specify
a value greater then the Lower
Limit by at least 8 using the +
and – keys.
0 – 5 - 73 Specifies the lower limit
temperature for boot-up
restriction in Celsius. Do not
specify 4 degrees or lower.
Specify a value smaller than
the "Upper Limit" value by at
least 8 using + and – keys.
Choices or
Display Only Description
Enable or disable the remote
Disabled
power-on feature via the
Enabled
network.
When "Enable" is selected,
change the "AC-LINK" setting
in the "System Hardware" to
"Stay Off".
Choices or
Display Only Description
Disabled Select a serial port to connect
the HW console.
On-board COM B
Selecting "On-board COM B"
changes "Boot-time Diagnostic
Screen" to "Enabled".
57.6K Enables the specified baud
19.2K rate.
No Flow Control Enables flow control.
XON/OFF
Direct
Indicate whether the console is
Via Modem connected directly to the
system or a modem is used to
connect.
Your Setting
Your Setting
Your Setting
Configuring Your System 3-13