No Characters Appear On Screen; Characters Are Distorted Or Incorrect - NEC EXPRESS 320Lb User Manual

No Characters Appear on Screen

Check the following:
!
Is the keyboard working? Check to see if the Num Lock light is functioning.
!
Is the video display monitor plugged in and turned on? Many modern video monitors
shut down when inactive and may require a moment to warm up when activated.
!
Are the brightness and contrast controls on the video monitor properly adjusted?
!
Are the video monitor switch settings correct?
!
Is the video monitor signal cable properly installed?
!
Is the video controller installed?
If you are using an add-in video controller board, do the following:
1. Verify that the video controller board is fully seated in its connector in the I/O
module (and verify that the video monitor is plugged in to the ACTIVE video
controller).
2. Reboot the system for changes to take effect.
3. If there are still no characters on the screen after rebooting the system and POST
emits a beep code, write down the beep code you hear. This information is useful
for your service representative. See "Post Error Codes and Messages" later in this
chapter.
4. POST emits one long beep and two short beeps pattern to indicate a possible
problem with the video display controller. If you do not receive a beep code and
characters do not appear, the video display monitor or video controller may have
failed. You can verify this by trying the monitor on another system or trying a
different monitor on this system. Contact your service representative or authorized
dealer for assistance.

Characters are Distorted or Incorrect

Check the following:
!
Are the brightness and contrast controls properly adjusted on the video display?
Refer to the documentation supplied with your video display.
!
Are the video monitor's signal and power cables properly installed?
!
If the problem persists, the video monitor may be faulty or it may be the incorrect
type. Contact your service representative for assistance.
5-10 Problem Solving