Post Error Codes And Messages - NEC EXPRESS 320Lb User Manual

POST Error Codes and Messages

Whenever a recoverable error occurs during POST, BIOS displays a message on the
video display screen to indicate both status and error conditions and causes the speaker
to beep as the message appears. BIOS also issues a beep code (one long tone followed
by two short tones) during POST if the video configuration fails or if an external ROM
module does not a checksum of zero. The BIOS indicates errors by writing an error
code to the standard logging area in the Extended BIOS Data Area, and by displaying a
message on the screen, which is sometimes preceded by the POST Error Code. The
error code is also logged to the Event Logging area.
Recommended actions are specified for each error condition and some will prompt you
to remove and replace CRUs. Refer to Chapter 4 for the CRUs associated with the error
codes displayed.
Table 5-1 POST Error Codes and Messages is a list of the error codes and messages
written at the start of each POST test. Table 5-2 POST Error Beep Codes is a list of
beep codes issued for each POST test.
Error Code and Message
0200 Failure Fixed Disk
0210 Stuck Key
0211 Keyboard Error
0212 Keyboard Controller Failed
0213 Keyboard Locked - Unlock
Key Switch
0220 Monitor type does not match
CMOS - Run SETUP
5-26 Problem Solving
Table 5-1. POST Error Codes and Messages
Description
Keyboard connection error.
Keyboard is faulty.
Keyboard controller is
faulty.
Keyboard is locked.
Illegal monitor type is
specified.
Configuration error in
Setup menu.
Hard disk is faulty.
CPU module board is
faulty.
PCI module board is
faulty.
Action
Check configuration in
Setup menu.
Replace the hard disk.
Replace the CPU module
board.
Replace the PCI module
board.
Disconnect and reconnect
the keyboard.
Replace the keyboard.
Replace the PCI module
board.
Check the keyboard
connection.
Restart the server.
Replace the PCI module
board.
Unlock the key switch.
Select "Get Default Value"
from the Setup menu.
Clear the CMOS data.