NEC EXPRESS 320Lb User Manual page 151

Table 5-3. POST Error Codes and Messages (continued)
Error Code and Message
0B22 CPUs are installed out of order CPU is faulty.
0B28 Unsupported Processor
detected on Processor 1
0B29 Unsupported Processor
detected on Processor 2
0B30
CPU FAN #1 Alarm occurred
0B31 CPU FAN #2 Alarm occurred
0B32
CPU FAN #3 Alarm occurred
0B40 Invalid System Configuration
Data
0B41
System Configuration Data
Read error
Resource Conflict
0B42
0B43 Warning: IRQ not configured
Expansion ROM not initialized
0B44
0B45
System Configuration Data
Write error
Missing date and time
0B47
synchronization
0B49
BMC Issued Reset Command,
but failed System Reset
0B6E DIMMs are installed out of
order
0B70
The error occurred during
temperature sensor reading
0B71
System temperature out of
Range
5-28 Problem Solving
Description
The processor (CPU) not
supported by this server is
installed in Processor 1.
The processor (CPU) not
supported by this server is
installed in Processor 2.
Dust obstructing the fan.
Fan is faulty.
CPU module board is
faulty.
Dust obstructing the fan.
Fan is faulty.
PCI module board is faulty.
Configuration error in
SETUP.
CPU/PCI module board is
faulty.
Configuration error in
SETUP.
CPU/PCI module board is
faulty.
Configuration error in
SETUP.
Configuration error in
SETUP.
Configuration error in
SETUP.
Configuration error in
SETUP.
CPU/PCI module board is
faulty.
The date and time are
incorrect due to a
communication error
between BMCs.
System cannot be reset by
BMC's reset command.
DIMM is faulty.
SMBus device is faulty.
SMBus is faulty.
Fan is faulty.
CPU/PCI module board is
faulty.
Action
Replace the CPU.
Install the CPU appropriate to
the server.
Install the CPU appropriate to
the server.
Replace the fan.
Replace the CPU module
board.
Connect fan cable properly.
Replace the fan.
Replace the PCI module
board.
Connect fan cable properly.
Reset the setting by selecting
[Yes] at [Reset Configuration
Data]
Replace the CPU/PCI module
board.
Reset the setting by selecting
[Yes] at [Reset Configuration
Data]
Replace the CPU/PCI module
board.
Correct device configuration in
SETUP
Correct settings in SETUP
In SETUP, disable
decompression of expansion
ROM on unnecessary optional
PCI cards.
Reset the setting by selecting
[Yes] at [Reset Configuration
Data]
Replace the CPU/PCI module
board.
Restart the system.
Re-set the date and time in
SETUP.
If the error persists, replace the
PCI module board.
Replace PCI module board.
Replace DIMM.
Replace the CPU/PCI module
or front panel board.
Clean the fan.
Replace the fan.
Replace the PCI module
board.